Victron BANL-E Fuse Holder for ANL-fuse 90x22mm 10mm Screw OF010150
Victron Energy BANL-E Fuse Holder for the safe installation of DC ANL-Fuse strip fuses, without cover, 90x22x14mm, on-centre spacing 60mm, screw Ø10mm.
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
Victron Energy BANL-E Fuse Holder for ANL-fuse
The BANLE fuse holder from Victron Energy (MPN CIP106100000) is used for the safe installation of DC ANL-Fuse strip fuses. The holder is equipped with nuts and snap rings to ensure the lowest possible contact resistance. ANL fuses can be used in circuits with a high operating voltage of up to 80V/DC.
Fuses of the ANL-Fuse type are strip fuses and are screwed directly to the holder to ensure optimal contact. Corresponding nuts and snap rings are already pre-assembled on the holder.
Area of application of the ANL fuses
Areas of application for ANL fuses are power networks with an operating voltage of up to 80V/DC, such as in many electric forklifts. But ANL fuses are also often used in the marine sector.
Features:
500A max. current at max. 80V DC
For ANL-Fuse type fuses
For safe installation with low contact resistance
Material: high-strength plastic mixture
Base 90x22x14 mm.
Height 46±2 mm.
On-centre spacing 60 mm.
Screw Ø10 mm.