Gelcoat FILLER 4in1 White two-component putty 200g N70749900007
Gelcoat FILLER 4in1 Two-component, spreadable putty for DIY nautical applications, with a final touch like that of a glossy and brilliant paint, white color, 200g.
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
Gelcoat FILLER 4in1 White two-component putty
GELCOAT 4in1 putty is a two-component system designed and formulated for "do-it-yourself" nautical applications. It is used like normal stucco, but its final effect is that of a shiny and brilliant paint. In a single step it is possible to repair small damage to the gel coat and after polishing the damaged part will return as good as new.
TECHNICAL DATA
Specific weight: 1300 ± 20 g/l;
V.O.C.: 45 ± 2 g/l;
Viscosity: 2100 ± 200 Pas;
Consistency: 800 ± 200 Pas;
Gloss 60°: > 90;
White color.
STORAGE
Store the packages tightly closed and in a cool (temperature below 25°C) and ventilated place for a maximum of 12 months starting from the production date highlighted on the jar. Avoid direct exposure to sunlight.
APPLICATION
Make sure that the surfaces to be grouted are perfectly dry and clean, it is better to sand them with P 80 and/or P 150 abrasive paper.
Using clean tools, remove the quantity to use from the jar, adding 1 - 3 grams of hardener for every 100 grams of product.
Mix this quantity by amalgamating the two components well.
Apply the stucco to the surface to be worked on, keeping in mind that the product can be sanded after approximately sixty minutes; hardening times can be altered depending on the ambient temperature: they are shortened with temperatures above 25 °C and longer with lower temperatures.
Do not put catalyzed and/or unused stucco back into the can to prevent the entire contents of the can from deteriorating; close the jar after use, in order to prevent the product from hardening upon contact with air
After complete drying, sand the filled part with grits P80, P240, P400 and 1000; then polish with LEVANTE POLISH ABRASIVE.
