Rule LoPro LP900S 900GPH 3400 lt/hour 12V Bilge Pump 38522559
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
Designed to bring pumping power to tight spaces.
Rule’s LoPro Series Bilge Pumps are only 2.25”high. The 900S model features two automated modes. The first one engages the pump when the water level reaches 2” or 1.3” (user choice); and the second one checks for water by briefly turning on the pump every 2.5 minutes.
- Multiple modes of operation: The 900S features two automated modes of operation
- Horizontal or vertical mounting: The 900S features a variety of mounting options to accommodate the boat’s design
- High or low water sensing mode: The pump starts when water reaches a 2” level. By turning the motor cartridge upside down, the sensor is at 1.3”
- Electronic automatic mode: The pump automatically turns on every 2.5 minutes to check for water, and if it’s detected the pump stays on until the water is gone.
- Fully rotating discharge body: The entire body swivels up to 180°, making the pump extremely easy to install.
- Threaded discharge nozzle: Multiple ports are available for this pump.
- ¾” straight, ¾” right angle; 1”, 1-1/8”
- All ports are included in the aftermarket package
- Backflow prevention. New tricuspid check valves help prevent backflow
Specifications LP900S:
Voltage: 12Vdc
Flow: 900GPH open flow at 13.6V
Amp Draw: 4A approx
Protection: TCO
Port Configuration: 3/4”, 1”, 1-1/8” Straight, 90 degree 3/4”
Backflow preventer valve can be used with straight fittings
Height: 2.3”
Length: 7.6”
Width: as little as 2.3”
