Boero Orion Extra Antifouling For Propellers, Shafts and Outdrives 0,25 Lt 065 Volvo Grey 45100201
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
Boero Orion Extra Antifouling For Propellers, Shafts and Outdrives. 0,25 Lt .065 Volvo Grey.
Insoluble matrix antifouling specific for protecting propellers, steel shafts and aluminium outdrives from marine fouling.
PHYSICAL ASPECTS (at 20°C)
Finish: Thixotropic
Colour: Grey .715
Solids (by volume): 50 ± 2 %
Specific gravity: 1,78 ÷ 1,82 g/cm³
Flash point: 30° C
Viscosity: 5.000 ÷ 10.000 cP
APPLICATIONS DATA
Application method: Thinner 693.000 (max. 5 %)
Dry film thickness: Standard range of application 50 μ - 70 μ (Recommended 60 μ)
Wet film thickness: Standard range of application 100 μ - 140 μ (Recommended 120 μ)
Theoretical yield at the thickness indication m2/litre: Application range at the thickness recommended 10
Recommended primers: Anticorrosiva CR – Mistral Fondo – Delta 3000 – Delta UC HB – Ancorprimer
SURFACE PREPARATION
Aluminium sterndrives: clean surface well and degrease if necessary; sand with fine grit sandpaper, remove dust and apply a cot of ORION PRIMER, after 6-8 hours apply a first coat (low thickness) of ORION EXTRA.
Bronze propellers and steel shafts: clean surface well and degrease if necessary;sand with thick grit sandpaper, wash with thinner to eliminate all traces of grease and dust, apply one coat of ORION PRIMER, after 6-8 hours apply a first coat (low thickness) of ORION EXTRA. If necessry, dilute by 5-10% with Thinner 693.
dopo 6-8 ore applicare una prima mano a basso spessore di ORION EXTRA. Diluire eventualmente al 5-10% con Diluente 693.
CONDITIONS DURING APPLICATION
Ensure there is adequate ventilation when the paint is applied in confined spaces.
