Veneziani Gummipaint antifouling 0,5Lt Grey N709473COL1199
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
Veneziani Gummipaint antifouling
Antifouling characterised by an elastic matrix, suitable for inflatable rafts. Excellent antifouling power. Suitable for painting supports in neoprene, rubber-coated, PVC and Hapalon. Excellent flexibility and adhesion. It complies with the IMO (AFS/CONF/26) antifouling requirements and contains active substances according to the BPR Regulation (Regulation (EU) No 528/2012).
Product information
Finish Matt Grey.714 The colour of the antifouling paint after diving may be slightly different. Small tinting differences may occur between different production batches: in case mix them before the application.
Solids (by volume) ASTM D2369 27 ± 2 %
Specific gravity UNI EN ISO 2811-1 1,25 ÷ 1,35 g/cm³
Flash point UNI EN ISO 13736 + 13° C
Average shelf life 3 years VOC (calculated average content) ISO 11890-2/2006 614 g/l
SURFACE PREPARATION
Degrease the surface to be treated with an appropriate solvent or detergent. Pressure wash using freshwater, in order to remove any trace of wax and grease. All the surfaces to be painted must be clean, dry and free from any contaminant agents. Sand down using abrasive paper n° P150-P180 and use a primer on all the surface. Before proceeding with the application of the products, blow with fresh and dry air, in order to remove any residual of sanding and dirt. Mix the antifouling for a few minutes, in order to guarantee its complete homogeneity. Reduce the raft’s pressure by 20%, before proceeding with the application of GUMMIPAINT A/F by brush or spray.
By brush: apply by making horizontal strokes than the waterline , with a uniform and constant thickness, going over the coast no more than 3 times on the same point. For this type of application, dilute withThinner 6380 up to maximum of 5-10% in volume.
By spray: It is necessary to dilute with Thinner 6380 between 20-30% in volume, following the indication in the next page. Do not launch the hull before 24 hours from the last coat application.
Recommended thinner 6380, our code COL254.
Unit size 0,5 lt.
Colour: Grey.
