Veneziani WOOD SB-PROTECT 7W6.521 1L .000 TC Impregnating agent YM473COL511
Veneziani WOOD SB-PROTECT 7W6.521 two-component impregnating agent or the impregnation of precious types of wood, marine plywood and MDF panels, .000 Colorless, 1 liter.
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
Veneziani WOOD SB-PROTECT 7W6.521 .000 Colorless Two-component impregnating agent
SB-Protect is a two-component insulating product for the impregnation of precious types of wood, marine plywood and MDF panels. Its penetration and insulation characteristics make it possible to obtain surfaces that can be easily sanded and covered with single or two-component products, to create both pigmented and transparent finishes. It is recommended to be used mainly on new or perfectly bare wood.
Application: brush.
TECHNICAL SPECIFICATIONS
Theoretical coverage: 13,3 m2L
Mixing ratio: 1:1
Recoating time: wet on wet 0,5 - 1h (20° C)
Hard dry: 10h
Thinner: 6780
Finish: Glossy
Color: Colorless .000
Pack: 1 liter
SURFACE PREPARATION
New or renewed wood: The humidity of the wood must not exceed 18%, sand the surface thoroughly with paper n. P120 - P180, before proceeding with the application of SB-Protect, blow with clean and dry air to remove any residual sanding and dirt. The substrate must be
sound, dry, free from traces of dirt, grease, resin, and old paints.
Apply the first coat of SB-PROTECT; if necessary, dilute the first coat at 15 - 20% then apply additional coats one or two hours apart until the wood is saturated. After 24 hours, sand with fine 320 - 400 paper, blow with clean, dry air and proceed with the application of the V-Shine
or VB-Shine paints.
N.B. Between coats, sand with fine Scotch Brite (gray).
