Veneziani Sentiflex Enamel For Bilges 0,75 Lt Grey 473COL315
One component enamel for bilges. Gloss enamel for bilge based on special resins to give good chemical properties, in particular against ingress of moisture, oils, lubricants, fuel and detergents.
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
MORE INFORMATION
SENTIFLEX ONE COMPONENT POLISH FOR BILGES
EASY APPLICATION
EXCELLENT LEVELLING
GOOD COVERAGE
RESISTANT TO LUBRICATING OILS AND FUEL
FOR WOOD, STEEL, ALUMINIUM AND FIBREGLASS
FEATURES:
Gloss enamel for bilges based on special resins to give good chemical properties, in particular against penetration of moisture, oils, lubricants, fuel and detergents. This odourless enamel can be applied directly, after preparation, on fibreglass, wood, steel and aluminium. Easy to apply, has good coverage power with excellent levelling.
TECHNICAL DATA
Cuinge mechanism: evaporation of the solvent and chemical reticulation
Specific weight: 1.12 ± 0.02 kg / l
Volume solids: 51%
Flash point: + 35 ° C
Appearance of film: glossy
Colour: Grey
Unit size: 0,75 l
SURFACE PREPARATION
The product is applied directly on clean, degreased and possibly sanded surface.
For new wood, primed with Fibrodur.
For new gel coat, degrease with Detersil, sand and then apply the product.
For new steel and aluminium, primed with Miniax Plx or Epoxy Primer
For the application on old single-component enamels, scrape off parts that are flaking.
APPLICATION PROCEDURES
Stir the product before use until it is completely even. Generally it does not require any dilution. Should it be necessary, then add Thinner 6470 up to a maximum of 5% by volume. Apply a uniform and wet thickness in order to ensure uniform coverage. To obtain adequate chemical resistance, apply two coats of the product with an interval recoating time of at least 8 hours at T = 20°C .
APPLICATION DATA
Drying time (20°C): 24 hours
Pot life (20°C): /
Application temperature min / max: + 5 / + 35 ° C
Hardener: /
Mixing ratio by volume: /
Mixing ratio by weight: /
Thinner: 6470
Wet film thickness per coat: 80 μ
DFT per coat: 40 μ
Theoretical coverage: 12.7 m2 / l
Recoating time at 20 ° C at least 8 hours - maximum /
Number of coats: 1-2
Unit size of 0.75lt. Grey colour.
