Veneziani Epoway Primer 2,5 Lt A+B White 473COL222
Two-coponent epoxy undercoat with barrier effect, which can be applied to any kind of substrate (wood, steel, aluminium and GRP).
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
Two-component epoxy undercoat with barrier effect, which can be applied to any kind of substrate (wood, steel, aluminium and GRP). This coating may be used both as barrier coat and as undercoat for enamels. Can be recoated, after sanding, with two-pack enamel. Can be painted over with two-component products after proper sanding.
MORE INFORMATION
SURFACE PREPARATION
For areas already treated it is important to proceed with removal of all old flaking paint.
- New Gelcoat: degrease with Detersil, rinse and sand the surface with 220-240 grit sandpaper.
- New wood: relative humidity of the substrate must be less than 18%. Sand with 80-120 grit sandpaper and remove residues before applying a well-diluted first coat of primer or of the same Epoway diluted by 25%;
- New steel: Sandblasting SA 2½ is recommended or ST3 disc sanding and priming with 1 or 2 coats of ADHERPOX;
- New light alloy: degrease with Detersil and disk sanding with coarse sandpaper and prime with 1 or 2 coats of ADHERPOX.
APPLICATION PROCEDURE
Stir the base well and slowly pour in the hardener. The two components must be stirred until a complete even. It is recommended to dilute with Thinner 6610 up to a maximum of 20% by volume for spray application.
24 hours after application it will be necessary to sand the surface with 320-400 grit sandpaper in order to obtain a perfectly smooth surface before proceeding with the application of finishes, such as Gel Gloss Pro or Commander.
Unit size 2.5lt. White colour.
