Veneziani Adherglass Anchoring Primer for fiberglass 750ml Pink 372 N709473COL230
Adherglass Veneziani is a one component primer for one-component antifouling for new or bare hulls in fiberglass or gelcoat. Unit size 0,75 Lt. Colour: Pink.
Visit us in our shop
WE ARE AT YOUR DISPOSAL AT OUR POINT OF SALE
Not just online! Come and visit us also in the shop!
In our store you will find a wide selection of selected items and you will be assisted by our specialized staff with over a decade of experience in the nautical sector.
Everything for the boat ... deck equipment, anchoring and mooring, hydraulic and electrical systems, photovoltaics, stainless steel hardware, antifouling and paints, engine spare parts, on-board safety, sailing accessories, nautical instruments, GPS, depth sounders and much more!
We are in San Giorgio di Nogaro in the province of Udine, an important basin, located in the Bassa Friulana, bathed by the Corno river ... a few km from well-known destinations such as Lignano, Grado, Trieste etc.
Nautimarket Europe s.r.l., Via Marittima 17, 33058 San Giorgio di Nogaro (UD) Italy
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
(modificale nel modulo Rassicurazioni cliente)
Veneziani Adherglass Anchoring Primer for fiberglass 750ml Pink 372
ADHERGLASS PRIMER
ADHESION PRIMER FOR GRP
Adherglass is a primer which is based on synthetic polymers. It is a one-pack primer providing good adhesion and suitable for use on gel coats, GRP and epoxies such as Plastolite Pro and Aquastop. Adherglass is quick-drying and is used principally as a primer for antifouling on GRP or on new or stripped gel coats. The surface does not require sanding to guarantee good adhesion, but must be thoroughly degreased.
TECHNICAL DATA
Specific weight: 1.21 ± 0.02 Kg/L
Volume solids: 20 %
Colour: .372 pink
Unit size: 0.75 L
APPLICATION DATA
Application: Brush - Paint roller
Drying time before use at 20°C: 6 hrs
Thinner: 6780 for cleaning only
Dry film thickness per coat: 15 microns
Wet film thickness per coat: 75 microns
Theoretical coverage per coat: 13,3 m2/L
Recoating time at 20°C: min 6 hrs
Number of coats: 1
SURFACE PREPARATION
- New gel coats: degrease with Detersil and rinse with fresh water. If there are traces of mould-release wax, the gel coat should be lightly wet-sanded with 400 grade abrasive paper until the surface of the gel coat becomes dull.
- Old gel coats: the product should be applied directly to the stripped gel coat or to an Epoxy Primer.
APPLICATION
Thoroughly stir the content, making sure that no sediment is left on the bottom. The product is ready to use and does not need to be thinned. Adherglass is best applied with a brush. Apply a thin layer so that it appears almost transparent on the surface. If too thick a layer is applied the following layer of antifouling will not adhere well. When painting is finished, clean the brushes immediately with Thinner 6780.
Theoretical yield 13.3 m2/L.
Specific weight 1,21.
Recoating time at 20 ° C - minimum 6 hours.
Recommended thinner 5780, our code COL252, for cleaning only.
